HomeStore

Caple 1.5 Bowl Sink MODE3415-R-GM - Gunmetal

Product image 2
Product image 3

Caple 1.5 Bowl Sink MODE3415-R-GM - Gunmetal

Caple Mode 3415 Right Handed Inset Or Undermounted Sink

Key Specification

  • 1.5 Bowl Sink
  • Right Handed Small Bowl
  • Bowl Depth (Main) 200mm
  • Small Bowl Depth 135mm
  • Min. Base Unit 600mm

Design

  • Gunmetal Stainless Steel

Features

  • 1.2mm Brushed Stainless Steel
  • Right Handed Small Bowl
  • No Tap Facility
  • 2x 90mm Waste Outlets For A Basket Strainer Waste
  • Suitable For A Waste Disposer
  • Wastes And Overflows Included

Fitting Options

  • Inset
  • Undermounted
  • Cpk200 Plumbing Kit Available At Extra Cost

Please Note

  • When Inset Fitting The Mode Sinks, A Recess/Notch Will Need To Be Made In The Underside Of The Worktop To Enable The Overflow To Be Fitted To The Sink. View A Shows Theworktop From The Underside. Check The Required Position Of The Recess/Notch By Offering The Sink (With Overflow Fitted) Into The Cut-Out. Then Mark Your Worktop In The Required Position. (For Guidance The Recess/Notch Should Be Approximately 75mm Wide And 25mm Deep, And 10mm From The Top Edge Of The Worktop. When Cutting The Recess/Notch Ensure There Is Enough Clearance For The Complete Overflow Body.
$245.59

Original: $701.70

-65%
Caple 1.5 Bowl Sink MODE3415-R-GM - Gunmetal—

$701.70

$245.59

Product Information

Shipping & Returns

Description

Caple Mode 3415 Right Handed Inset Or Undermounted Sink

Key Specification

  • 1.5 Bowl Sink
  • Right Handed Small Bowl
  • Bowl Depth (Main) 200mm
  • Small Bowl Depth 135mm
  • Min. Base Unit 600mm

Design

  • Gunmetal Stainless Steel

Features

  • 1.2mm Brushed Stainless Steel
  • Right Handed Small Bowl
  • No Tap Facility
  • 2x 90mm Waste Outlets For A Basket Strainer Waste
  • Suitable For A Waste Disposer
  • Wastes And Overflows Included

Fitting Options

  • Inset
  • Undermounted
  • Cpk200 Plumbing Kit Available At Extra Cost

Please Note

  • When Inset Fitting The Mode Sinks, A Recess/Notch Will Need To Be Made In The Underside Of The Worktop To Enable The Overflow To Be Fitted To The Sink. View A Shows Theworktop From The Underside. Check The Required Position Of The Recess/Notch By Offering The Sink (With Overflow Fitted) Into The Cut-Out. Then Mark Your Worktop In The Required Position. (For Guidance The Recess/Notch Should Be Approximately 75mm Wide And 25mm Deep, And 10mm From The Top Edge Of The Worktop. When Cutting The Recess/Notch Ensure There Is Enough Clearance For The Complete Overflow Body.